Sunguard RV Windshield Covers
Attach the adhesive "hook" patches to their "loop"
counterpart patches sewn on the covers. (Do not peel
off their adhesive film backings yet).
With the front of the rig clean, dry and dust free,
tape up the covers using masking tape.
Peel off the adhesive film backing from the top-center
Press the top-center adhesive patch (above the windshield)
firmly into place.
Mount the bottom-center patch, then mount the four
corner patches accordingly.
Mount the side covers in the same way.
Note: When you order
Velcro® type installation, the Sunguard
covers arrive ready to install with snaps, as
well. In that way, if the customer would rather
convert to snaps (for a tighter fit), the snaps
are ready to install and do not have to be sent
back to the factory.
type adhesive patches can be safely and easily
removed from the rig! Simply saturate the patches
with WD-40® for a few minutes. After removing
the old patches, the adhesive residue may be
removed with soap and water or any standard